Docking Station; Docking Station Controls - Stihl Rmi 522 C Manuel D'utilisation

larger mown area.
Sufficient clearance (at least 5 cm)
between the robotic mower and obstacles
must be ensured for edge following
( 9.12), ( 11.13). If necessary,
increase the wire clearance to the
obstacles.
Narrow edge clearances should
always be noted in the garden
sketch. ( 12.2)
Narrow edge clearances at the internal
corner:
Route the perimeter wire (1) as illustrated
at the internal corner. Use the
iMOW® Ruler (2).
0478 131 9965 D - EN
Narrow edge clearances at the external
corner:
Route the perimeter wire (1) as illustrated
at the external corner. Use the
iMOW® Ruler (2).

13. Docking station

13.1 Docking station controls

A circular red LED (1) provides information
on the status of the docking station and the
wire signal.
Function button (2):
– Switching docking station on and off
– Activating Homecall
– Activating find wire break
LED does not illuminate:
– Docking station and wire signal are
switched off.
LED illuminates continuously:
– Docking station and wire signal are
switched on.
– Robotic mower is not docked.
LED flashes slowly (2 seconds on –
briefly off):
– Robotic mower is docked, battery is
charging if required.
– Docking station and wire signal are
switched on.
LED flashes rapidly:
– Perimeter wire is interrupted – wire
break or wire is not correctly connected
to the docking station.( 16.6)
LED illuminates for 3 seconds, followed
by 1 second pause:
– Homecall was activated.
LED gives 3 short flashes, 3 long
flashes, 3 short flashes, followed by
approx. 5 second pause (SOS signal):
– Error in the docking station.
Switching the docking station on
and off:
The docking station is switched on
and off automatically during automatic
operation.
157