Cameo CLPFLATPRO7G2 Manuel D'utilisation page 14

DMX DELAY
The DMX Delay function is a simple way to create a running light effect with a large number of
spotlights that are all the same model and that are all running the same software version. This is
otherwise only achievable with a suitable DMX controller and time-consuming programming. All
the spotlights used in this are set to the same DMX operating mode and controlled via the same
DMX start address.
Manually setting the DMX delay for DMX modes without DMX delay channel:
Starting from the main display, press MENU to enter the main menu. Use the buttons  and 
to select the menu item DMX Delay and confirm with ENTER. Again use  and  to select the
desired submenu item, confirm with ENTER and set the value or status accordingly. Confirm all
entries with ENTER. Assign the spotlights to one of up to 47 groups as desired (maximum group
number depends on the activated DMX operating mode). Multiple spotlights may be assigned to
a group. The group number is also the factor by which the set delay time is multiplied. The delay
time (delay time of the DMX signal) can be set manually at each spotlight separately with different
values (0.0 s to 2.0 s in 0.1 s increments).
Setup example:
14