Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11.
Tighten the rear screws (do not tighten firmly).
12. After adjusting the kerf boards, release the stopper pin for
handle lock and raise the handle. Then tighten all the screws securely.
NOTICE:
After setting the bevel angle, ensure that
the kerf boards are adjusted properly. Correct adjust-
ment of the kerf boards helps to provide proper support
of the workpiece and minimizing workpiece tear out.
Maintaining maximum cutting capacity
This tool is factory adjusted to provide the maximum
cutting capacity for a 216 mm (8-1/2") saw blade.
When installing a new circular saw blade, always check
the lower limit position of the circular saw blade, and if
necessary, adjust it as follows:
1.
Remove the battery cartridge. Then, push the carriage
toward the guide fence fully and lower the handle completely.
1
► 1. Adjusting bolt 2. Guide fence
2.
Use the hex wrench to turn the adjusting bolt until the
circular saw blade comes slightly below the cross section
of the guide fence and the top surface of the turn base.
2
3.
Rotate the blade by hand while holding the handle
all the way down to be sure that the circular saw blade
does not contact any part of the lower base. Re-adjust
slightly, if necessary.
WARNING:
blade and with the battery cartridge removed,
always be sure that the circular saw blade does
not contact any part of the lower base when the
handle is lowered completely. If a circular saw
blade makes contact with the base, it may cause
kickback and result in serious personal injury.
Stopper arm
The lower limit position of the circular saw blade can be
easily adjusted with the stopper arm. To adjust it, move
the stopper arm in the direction of the arrow as shown
in the figure. Turn the adjusting screw so that the blade
stops at the desired position when lowering the handle
fully.
1
► 1. Hex wrench 2. Adjusting screw 3. Stopper arm
CAUTION:
Always hold the handle firmly
when adjusting. Failure to do so may cause the
carriage to jump up and result in injury.
14 ENGLISH
After installing a new circular saw
2
3
Publicité
Table des Matières
