Miele PWM 511 Schéma D'installation page 4

en - Installation notes
4
Explanation of the safety notes and warnings on the machine
Read the operating instructions
Read all the instructions, e.g., the installation instructions
Warning, hot surfaces
Warning, voltage up to 1000 volts
Grounding
Equipotential bonding
Installation requirements
 WARNING: The washing machine must be installed by Miele
Service or by properly trained staff of an authorized dealer.
This washing machine must be installed in accordance with all rele-

vant regulations and standards. Local energy supplier regulations must
also be observed.
This washing machine must only be operated in a room that has

sufficient ventilation and which is frost-free.
The washing machine should not be installed or operated in any
area where there is a risk of explosion.
General operating conditions
This washing machine is intended only for use in a commercial envi-
ronment and must only be operated indoors.
- Ambient temperature: 32-105°F (0-40°C)
- Relative humidity: non-condensing
- Maximum height above sea level of location site: 6500 ft (2000 m)
Depending on the nature of the installation site, sound emissions and
vibration may occur.
Tip: Have the installation site inspected and seek the advice of a spe-
cialist in instances where increased noise may cause a nuisance.
Transportation and site access
The machine must not be moved without the transport safety device
in place. Keep the transport safety device in a safe place. They must
be reequipped if the machine is to be moved again (e.g., when relocat-
ing the machine).