Hitachi WM 14DBL Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
CAUTION
1.
If liquid leaking from the battery gets into your
eyes, do not rub your eyes and wash them well
with fresh clean water such as tap water and
contact a doctor immediately.
If left untreated, the liquid may cause eye-problems.
2.
If liquid leaks onto your skin or clothes, wash well
with clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3.
If you find rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using
the battery for the first time, do not use and return
it to your supplier or vendor.
SPECIFICATIONS
POWER TOOL
Model
Capacity
Tightening torque
[when fully charged
at 20°C temp]
Edge shape
Motor
No-load speed
[when fully charged
at 20°C temp]
Number of blows
[when fully charged
at 20°C temp]
Rechargeable battery
Dimensions of the tool
Entire length × height × center height
Weight
LED light
Remaining battery indicator lamp
CHARGER
Model
Charging voltage
Weight
Electronic pulse mode
Bolt mode
Self drilling screw mode
Drill mode
Electronic clutch mode
Bolt mode
[Tightening time: 3 sec.]
Drill mode
Electronic clutch mode
Electronic pulse mode
Bolt mode
Self drilling screw mode
Drill mode
Electronic clutch mode
Electronic pulse mode
Bolt mode
Self drilling screw mode
UC18YRSL
14.4 V 18 V
0.6 kg
WARNING
If an electrically conductive foreign object enters the
terminals of the lithium ion battery, a short-circuit may
occur resulting in the risk of fire. Please observe the
following matters when storing the battery.
Do not place electrically conductive cuttings, nails,
steel wire, copper wire or other wire in the storage
case.
Either install the battery in the power tool or
store by securely pressing into the battery cover
until the ventilation holes are concealed to prevent
short-circuits (See Fig. 1).
Wood screw
Ordinary bolt
High tension bolt
Self drilling screw
Woodwork drilling
Steel drilling
Mortar drilling
Small screw
Maximum 30 N·m {306 kgf·cm}
Tightening is M10 high tension bolt (strength grade 12.9)
Hexagon socket used
11 N·m {112 kgf·cm}
5-point clutch 2.3 – 5.3 N·m {23 – 54 kgf·cm}
Width across flat 6.35, bit insertion shape
0 – 1100 min
0 – 640 min
0 – 1100 min
0 – 1100 min
0 – 450 min
0 – 1090 min
0 – 700 min
0 – 1090 min
BSL1430: Li-ion 14.4 V (3.0 Ah, 8 cells)
162 mm × 250 mm × 31 mm
(BSL1430 attached)
1.5 kg (BSL1430 attached)
WM14DBL
ø 4.2 × 75
M4 – M10
M4 – M6
ø 6
ø 21
ø 10
ø 6
M6
DC motor
-1
-1
-1
-1
-1
-1
-1
-1
White LED
Red LED
English
8

Publicité

Table des Matières
loading

Table des Matières