AERMEC AER503IR Manuel D'utilisation Et D'installation page 32

INSTALLATION OF THE AER503IR
PANEL
Installation:
AER503IR is compatible with flush and wall
mounted boxes, type: 502 (2 modules) and
503 (3 modules).
To install AER503IR, open the accessory using
a flat screwdriver, as shown in the figure.
POSITION • [m]:
DIMENSIONAL DATA • [mm]:
32
WARNING: in order to prevent potential
damage caused by accidental electrostatic
discharges, never touch the electronic board
with your bare hands.
Once installation is complete, remove the
protective film from the display
3 MODULE BOX
2 MODULE BOX
2 MODULE ROUND BOX
BE VERY CAREFUL NOT TO OVERTIGHTEN THE FIXING SCREWS.
TECHNICAL SPECIFICATIONS:
Power supply: 230 V +/- 15%, 0.2W
Operating temperature: 0...50°C
Storage temperature: -20...+80°C
Protection rating: IP20
Software class: A
ALTO • UP
•
ALTO UP
•
ALTO UP