Operating Features - Urmet 1092 Guide Rapide

ENGLISH
INSTALLATION
1 Make sure that no units are powered before starting the installation procedure.
2 Install the camera on the bracket and fasten it.
3 Position the bracket to frame the required picture and fasten it to the wall or other flat surface.
4 Connect the video output to the utility.
5 Power the camera.
6 Adjust the lens to frame the required images.
•
Remove the camera top.
•
Loosen the protective dome.
•
Turn towards WIDE "W" to move the subject away (the frame and angle become consequently
wider).
•
Turn towards TELE "T" to move the subject closer (the frame and angle become consequently
narrower).
•
Turn towards NEAR "N" to adjust focus of nearby subjects.
•
Turn towards FAR "∞" to adjust focus of faraway subjects.
Focus adjustment ring
VARIFOCAL adjustment ring

OPERATING FEATURES

The camera may be operated only using the UTC controls available on the DVR/HDVR of the Urmet
catalogue implementing the function. Refer to the complete product documentation on the Urmet website to
check for the list of available devices.
These controls can be used to access the OSD menu.
Refer to the respective product manuals for using the controls.
4
Blind spot covered
by LEDs
Focus adjustment ring lock
pin
VARIFOCAL adjustment ring
lock pin
DS1092-536