Accessories Provided; Installation Specifications; Installation Precautions; Operating Features - Urmet 1092/220M Manuel D'utilisation

ACCESSORIES PROVIDED


Instruction manual.
Important note: Accessories may be changed without prior notice.

INSTALLATION SPECIFICATIONS


Avoid pointing the lens directly towards the sun or intense sources of light also when the camera is
off. The subject must not be backlit.

Some lighting systems (e.g. coloured fluorescent lights) may false the colours.

Arrange a suitable circuit breaker and fuse upstream of the devices.

Make sure that the rating plate data correspond to the power specifications before connecting the
device to the mains.

INSTALLATION PRECAUTIONS


Though the device has an IP66 protection grade, there are particular environments (such as
seashores, harbours, wharves, etc.) that can accelerate corrosion of external parts. Also installation in
very dusty environments (quarries, mines, dusty materials, etc.) can compromise the optimal
operation.

To prevent device overheating, place it in a well aired position.

For the same reason, the device must not be installed near heat sources as radiators or warm air
ducts, in places where it is directly exposed to sun irradiation or in rooms with excessive dust
accumulation, subject to mechanical vibrations or impacts.

Consider the device operating temperature range (0°C÷+50°C) before choosing the place for
installation. Do not install the unit over another heating device.

Do not power the device on immediately after moving it from a cold place to a warm one and vice
versa. As a general rule, wait for three hours: the device needs this time to adapt to a new
environment (temperature, humidity, etc.).
INSTALLATION
1 Make sure that no units are powered before starting the installation procedure.
2 Install the camera on the bracket and fasten it.
3 Position the bracket to frame the required picture and fasten it to the wall or other flat surface.
4 Connect the video output to the utility.
5 Power the camera.

OPERATING FEATURES

The camera may be operated only using the UTC controls available on the DVR/HDVR of the Urmet
catalogue implementing the function. Refer to the complete product documentation on the Urmet website to
check for the list of available devices.
These controls can be used to access the OSD menu.
Refer to the respective product manuals for using the controls.
MENU USE
The camera ref. 1092/220M uses a multi-level menu that allows to enable/disable or change camera
settings.
MENUS SYSTEM DESCRIPTION
Once the menu access command has been performed, the access first screen will be displayed.
Once the item has been selected, the parameter can be changed choosing among the available options.
By selecting the item associated to the symbols
where other changes can be performed.
To quit the menu or the submenu and confirm the executed changes, select the item EXIT SAVE&END
and press the central button.
To reactivate the default values select the item EXIT RESET and press the central button.
14
or it is possible to access to the next submenu,
DS1092-541A