LD Systems LDHPA6 Manuel D'utilisation page 8

CONNECTIONS, CONTROLS, AND INDICATORS:
10 LEVEL METER (CH1 - CH6)
4-segment LED level meter for the headphone outputs channel 1 to 6 (HEADPHONE OUT CH1 - CH6). Once
the CLIP LED lights up, the line input is operating at peak level. It is not critical if the LED lights briefly at peak
levels for the incoming signal, however continuous illumination should be avoided by reducing the volume.
CAUTION: Very high sound pressure levels may occur that could permanently damage your hearing!
11
POWER
On / Off switch for the power supply of the device.
12
POWER LED
Lights up once the system is properly connected to the power mains and switched on.
13
MAIN INPUT LEFT / RIGHT (XLR)
Balanced line inputs on the left and right with 3-pole XLR connector.
14
MAIN INPUT LEFT / RIGHT (JACK)
Balanced line inputs on the left and right with 3-pole XLR connector.
15 MAIN OUTPUT LEFT / RIGHT (XLR)
Balanced line outputs left and right with 3-pole XLR connector (parallel to the MAIN INPUT LEFT / RIGHT).
16 MAIN OUTPUT LEFT / RIGHT (JACK)
Balanced line outputs left and right with 6.3 mm jack (parallel to the MAIN INPUT LEFT / RIGHT).
17 HEADPHONE OUT 1 - 6
Two parallel wired stereo headphone outputs with a 6.3 mm jack channel 1 to 6 The jacks are also wired in
parallel with the headphone jack (No. 6) of the corresponding channel on the front panel. Make sure that the
total impedance of all headphones connected to the corresponding channel does is not less than 8 ohms.
18
AC INPUT 115V / 230V
Switch for setting the operating voltage. The mains voltage of your power supplier and the operating voltage
of the device must be the same!
19 IEC POWER SOCKET WITH INTEGRAL FUSE HOLDER
IMPORTANT INFORMATION: BEFORE using this equipment, make certain that the mains voltage of your ener-
gy utility and the operating voltage of the device match! Always replace the fuse with a fuse of the same type
and values according to the supply voltage (see label on the rear panel) If the fuse blows repeatedly, please
contact an authorised service centre.
8