Hitachi D 10VF Instructions De Sécurité Et Mode D'emploi page 14

English
drilling torque decreased to about 70%. (Fig.
10)
(3) Installing the side handle (Fig. 11)
The side handle can be installed on either
side of the angle unit for right or left handed
use. To install the side handle, thread it into
the socket on the desired side of the angle
unit and tighten it securely.
(4) Removing chuck from angle unit (Fig. 12)
The chuck can be removed from angle unit in
the same manner it was removed from the
drill; however, ALWAYS REMOVE ANGLE
UNIT FROM
ATTEMPTING TO LOOSEN CHUCK. This will
prevent damage of drills gear. Use open end
wrench provided to hold angle unit spindle
before attempting to loosen chuck.
CAUTION:
If the chuck cannot be removed by striking
the wrench, don't strike the wrench forcibly
and send the drill to a HITACHI AUTHORIZED
SERVICE CENTER.
11. Attaching the hook. (Optional
accessory) (Fig. 13)
To attach the hook, it is necessary to
disassemble the handle portion which
covered the tool's electrical system. For your
continued safety and electrical shock
protection, installing the hook on this drill
should ONLY be performed by a HITACHI
AUTHORIZED SERVICE CENTER.
CAUTION:
When the power tool is used with a hook fixed to it, pay attention to the following points:
Before hanging the main unit from the waist belt, make sure that the drill has come to
a complete stop.
While it is suspended from the waist belt, the power plug must be disconnected from
the power source.
Do not walk about with the power tool hanging from the waist belot.
In the case of operation in a high place, it is dangerous to drop the tool accidentally. If
the hook is deformed or hung from the wrong position, there is danger that the hook will
slip off and the tool will fall.
Be careful to avoid danger.
In making a through hole, the power tool sometimes shakes violently when the
workpiece is pierced, from example. Be careful you are not hurt by the hook even if such
situation happens.
14
THE DRILL BEFORE
Side Handle
Fig. 11
Open End
Wrench
Hex. Bar Wrench
Fig. 12
Fig. 13
Hook (A)