Setting The Time; General Operation - AEG MRC 4159 P Mode D'emploi

English
68
USB CHARGE OUTPUT 1 A (MAX) Charging Socket
You can charge your Smart phone through this jack. Use the USB cable of your Smart
phone for the connection.
NOTE:
• Due to the different Smart phone types that are offered today, and their different
charging capacities, the loading duration is dependent on the Smart phone used
and its operating condition.
• Due to the design only a power supply of 1 A can be ensured. Devices such as
tablets PCs that need charging currents of up to 2500 mA, cannot be charged.
• A playback of audio-files through this connector is not possible. For the play-
back, use the USB PLAY jack.

SETTING THE TIME

1. Switch the device off.
2. Keep the TIME SET / M+ button pressed for a short time. The time indicator
begins to flash.
3. Set the hours with the HOUR / TU– /
MIN / TU+ / button.
NOTE:
If you do not press a button within 4 seconds, the settings are automatically accepted.
Projection
With this device, you can project the time onto a wall or the ceiling.
• You can switch this function on and off with the PROJECTION button.
• Rotate the projector to the desired position.
• The rear of the projector has a setting wheel with which you can adjust the sharp-
ness of the projection.

GENERAL OPERATION

Switch Device on / off
• Use the ON / OFF button to switch the device from standby to operating mode.
(FM or USB). The device turns on in the mode that was used before switching off.
• To disconnect the unit completely from the mains, pull the mains plug from the
socket.
MRC4159P_IM
button and the minutes with the
05.04.17