Copying And Downloading - Sony HSR-X200 Mode D'emploi

To turn on the sensor on or off
Check cells that correspond to the points on the screen
where you wish to activate the sensor.
To turn off the sensor for a cell, click on the cell again
to remove the check mark.

Copying and Downloading

If you logged on with ID2 or ID3, you can copy the
pictures recorded in the normal or alarm recording area
to the archive area of the HSR-X200/X200P and
download the data to the hard disk of your PC.
If you try to download data in the normal or alarm
recording area directly to your PC, the data are
automatically copied onto the archive area of the HSR-
X200/X200P for downloading. The data in the archive
area can be directly downloaded to your PC.
Copying a picture
1
Display the picture you wish to copy in Still
picture.
To copy pictures in series, display the first picture.
2
Click on (COPY).
The Copy Set display appears.
3
Specify the quantity of the images to be copied and
click on START.
During copying "COPYING TO ARCHIVE
AREA" is displayed.
When copying finished, "COPY FINISHED" is
displayed.
To exit Copy mode
Click on (PLAY STOP).
Downloading a picture
1
Display the picture you wish to download in Still
picture.
To download pictures in series, display the first
picture.
2
Click on (DOWNLOAD).
The Download display appears.
3
Specify the number of the images to be
downloaded and click on START.
When a picture in the archive area is displayed,
downloading immediately begins.
When a picture in the normal or alarm recording
area is displayed, downloading begins after first
copying the picture to the archived area of the
HSR-X200/X200P.
When downloading is started, the display changes to
the Image Viewer (see the next page), enabling you to
observe the picture being downloaded.
55
(GB)