WIKA MHC-1 Mode D'emploi page 18

6. Commissioning, operation
6.3 Configuration of the pressure sensor
Factory settings
Bit rate = 250 kbit/s
■
EN
CANopen: Node-ID = 1
■
J1939: Source address = 128
■
For further information on J1939 see "Additional instructions MHC-1 J1939"
The "Additional instructions" are available for download at www.wika.com.
6.4 EasyCom software installation
System requirement:
Operating system Microsoft
■
WIKA software EasyCom CANopen/J1939 (EasyCom CANopen/J1939 are available for download at
■
www.wika.com).
Windows is a registered trademark of Microsoft Corporation in the United States and other countries.
Installation
Connect the CAN adapter (PEAK PCAN-USB) to the PC and the pressure sensor.
■
Install driver (once).
■
Start the CAN software (EasyCom CANopen/J1939).
■
Make sure that the correct bit rate and node ID / address of the pressure sensor is used.
■
For further information on the CAN interface see "Additional instructions"
The "Additional instructions" are available for download at www.wika.com.
18
Windows 2000, XP, Vista or Windows
® ®
WIKA operating instructions pressure sensor, model MHC-1
7
®