HumanTechnik lisa signolux Plug-in receiver Manuel D'utilisation page 19

Setup
Connect the device
Plug the receiver into a well-visible mains socket. The event icons light up
once and the device is ready to use. This self-test lets you know that the
device is functioning properly.
Automatic pairing
Signolux devices can be used together immediately and without prior pai-
ring when unpacked. Which event icon is displayed depends on the type
of transmitter.
This information can be found in the user manual of the according trans-
mitter.
Optional manual pairing
Note 1:
If a transmitter is to be displayed with an event icon of your own choice,
this can be done as described in the chapter „Linking transmitter alerts with
event icons". However, this causes the receiver to lose the automatic pai-
ring function and all transmitters previously indicated on the receiver must
be individually paired.
Note 2:
Should there be repeated false alerts when using the preset transmitter
indication, this may hint at a neighbouring Lisa-Signolux-installation causing
interference. In this case, the problem can be solved by individually pairing
all transmitter and receiver units within the setup, see „Linking transmitter
alerts with event icons".
Reset to factory defaults
Delete the pairing of each event icon (see „Deleting transmitters"). When
all previously assigned transmitters have been removed from the memory
of the receiver, the automatic pairing is restored and the transmitters are
automatically displayed again.
English 19