Vetus WCP Instructions D'installation page 6

1 Introduction
The Vetus WCP toilets are marine toilets with an integrated
pump system. With correct installation and operation, these
toilets function like a normal toilet.
These Vetus toilets may only be used for pumping and
removal of faeces and toilet paper.
These toilet are not suitable for pumping other objects
such as cotton wool pads, tampons, sanitary towels, con-
doms or hair, or for pumping out fluids like oil. This could
cause damage!
Always make sure you have a pair of rubber gloves on board.
2 Operation
The particular cycle chosen is carried out automatically after
operating the appropriate button.
This cycle consists of:
• A flushing phase:
The magnetic valve allows a quantity of water to flow through
for a specified time. This water flows into the toilet bowl.
• A pumping phase:
The motor drives the pump blades. The faeces and toilet
paper are now ground up and pumped out.
A choice can be made between the 'ECO' cycle of about 10
seconds and the 'NORMAL' cycle that lasts about 20 seconds.
3 Safety
Ensure that the power supply is switched off during mainte-
nance or repairs.
Never put your hands in the hole in the toilet bowl. The blades
are not covered!
6
110129.01
Note!
4 items supplied
A toilet
B toilet seat
C set of fasteners for the toilet
D set of fasteners for the toilet seat
E hose clamps
F reduction piece
G electrical control unit
5 Installation
5.1 General
See Page 26 for installation examples.
Always install the toilet in accordance with the applicable regu-
lations of the country concerned. In some areas, it may not be
permitted to pump waste straight from the toilet into the water!
5.2 Fitting the toilet to the floor
Always mount the toilet on a sufficiently strong floor to prevent
the occurrence of point loads and the toilet bowl splitting. If
necessary fit an extra sheet of multiplex under the floor to rein-
force it.
• Place the toilet in the position required.
• Determine the position of the fitting holes. Use the toilet as a
template for this.
• Fit the toilet with the screws supplied.
• Attach the toilet using the fasteners supplied.
1x
1x
1x
1x
2x
1x
1x
B
A
C
Electric marine toilet WCP