Manta lovio HOME ChefAssistant Mode D'emploi page 18

The speed of the device drops
or is unstable.
The device sways and shakes
during operation.
The appliance arm does not
lower when the bowl cover is
in place.
Pollen, dirt in mixed
ingredients
Cleaning and maintenance
NOTE: The mixer and its components are not dishwasher safe. Make sure all components are dry before using
the appliance again after washing.
Discolouration or deformation can occur when exposed to high temperatures.
Cleaning the housing of the
appliance
1.The temperature in the room
is low, causing the lubricant in
the machine to harden.
2. the mixed ingredients are
too hard and there are too
many of them, which puts too
much strain on the machine.
3.Voltage is not stable.
1. the rubber suction cups in
the base of the unit do not
adhere properly.
2. the appliance is not placed
on a smooth and level surface.
Bowl cover incorrectly fitted,
bowl not fitted as instructed.
Dirt falls into the dough from
the main drive.
1. do not immerse the appliance in water. Do not direct the water jet
directly onto the appliance to prevent water from entering the
appliance and to avoid short circuits, electric shock, leaks, rust and
other malfunctions.
2. do not use cloths that are not well drained.
3. do not use detergent/vinegar/salt or other caustic, strongly acidic,
strongly alkaline cleaning agents to clean the appliance body.
Otherwise you may damage the surface of the appliance.
4 Do not use sharp or rough tools such as wire sponges to clean the
unit and accessories. Otherwise you will easily damage the surface.
5. Use a damp, soft cloth to clean the unit.
1.Remove the mixing vessel
and leave the machine in gear
"1" for 5 minutes to soften the
grease in the machine and
restore speed stability.
2. dilute the ingredients or
reduce the amount.
3.If the voltage is unstable, wait
until the voltage stabilises
before using the device.
1.Check that the suction cups
on the base of the unit fit
properly.
2.Place the unit on a smooth
and flat surface.
Turn the bowl cover so that it is
correctly fitted. Fit the bowl
according to the instructions.
Before use, check that the
main drive and accessories are
dry and that there is no water
or dust on the surface. Clean
the components with a damp
cloth.