Performing Settings - TESTO 417 Mode D'emploi

5.4 Performing settings

1
To open configuration mode:
✓
The instrument is switched on and is in measurement
view. Hold, Max or Min are not activated.
❯
Press and hold
changes.
- The instrument is now in configuration mode.
You can change to the next function with
You can leave configuration mode at any time. To do
so, press and hold
instrument has changed to measurement view. Any
changes that have already been made in configuration
mode will be saved.
2
To set funnel factor F.FACT:
For measurements at ventilation outlets with a funnel
the parameter F.FACT must be activated. The funnel
set (order no. 0563 4170) consists of a funnel for
measurements at plate outlets (200 x 200mm) and a
funnel for measurements at ventilation outlets (330 x
330mm).
✓
Configuration mode is opened, F.FACT is lit.
❯
Activate (on) or deactivate (oFF) the factor with
and confirm with
3
To set the area (only if F.FACT oFF):
✓
Configuration mode is opened, AREA is lit.
❯
Set the cross-sectional area with
confirm with
info@Testo-Direct.com
(for approx. 2s) until the display
(for approx. 2s) until the
.
.
Testo-Direct
www.
5. Operation 25
.
/
/ and
1.888.475.5235
.com