SilverCrest SRV35A1 Instructions D'utilisation Et Consignes De Sécurité page 13

During further use, the unit starts at the same
ventilation level that was selected during the last
operation.
If the mains adapter
meantime, the unit restarts in ventilation level
"003".
Note: During operation, the display continues to
light up for approx. 20 seconds before the display
goes out and switches to standby mode.
5.2 Switch off the unit
To return the unit to standby mode after
operation, press the button
NOTE: The unit switches off while the display 4
shows "000" for approx. 10 seconds and then also
switches off.
5.3 Select operating mode
To change an operating mode, press the
button 6 repeatedly until the desired mode
is shown on the display 4 . You can choose
between power, sleep and nature modes.
5.4 Selecting ventilation levels
Press the button
ventilation level you want.
You can choose between 20 different ventilation
levels.
The desired ventilation level is adopted directly.
Display Operating mode
Power mode
-P-
The unit switches to the highest level
of ventilation mode
is unplugged in the
17
1 .
2 repeatedly to reach the
Display Operating mode
Sleep mode
The maximum speed in sleep mode
is level 10. In sleep mode, the speed
is reduced by 4 levels and increases
by 2 levels after 10 seconds and
-S-
again by 2 levels after a further
10 seconds. The set speed is then
reached again. This interval runs for
30 minutes. After this time, the unit
reduces the speed by 2 levels each
time. This is repeated until level 2 is
reached.
Nature mode
Simulation of natural gusts of wind.
Every 10 seconds, the speed is
-n-
reduced or increased by 4 levels of
the set ventilation level.
Note: The lowest speed that can be
set in natural mode is therefore level
5 and the highest speed is level 16.
5.5 Timer function
The timer is used to switch off the unit automatically
after a preset time. The timer function can be set in
hourly intervals of up to 8h.
During operation, press the
the timer function. The hour indicator lights up.
Press the button
hour you want.
Wait approx. 10 seconds until the settings are
accepted.
After successful transfer, the display returns to
the current fan speed.
NOTE: A small dot flashes at the bottom right of the
display 4 to simulate the timer.
5 key to enter
5 repeatedly to set the
GB/IE/NI/CY/MT 13