Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
3. OPERATION
3.11 ADVANCED FUNCTIONS
This radiator incorporates the following functions:
Función
Adjustment of ºC or ºF
Adjustment of the control type
(PID, hysteresis, etc.).
Ajuste medición de temperatura
Firmware version.
Activación / Desactivación función
ventanas abiertas
Activación / Desactivación función
ITCS
Activación / Desactivación función
"hilo piloto" (Fil Pilote)
1
Press the
2
Press the
first setting, C1, appears on screen.
3
Press the
you wish to modify (C1 to C7), for example, C6.
Press
CERATECPRO
40
ACTION
button.
button again for 5 seconds.Then, the
buttons to choose the setting
to enter the setting you wish to modify.
Ajuste
This allows you to change from degrees
Celsius to degrees Fahrenheit.
This function is for users with knowledge
in electronics. Please do not enter this
function, it could reconfigure the device.
This allows you to calibrate and adjust the
temperature measured by the thermostat.
Version number of the device's firmware.
This allows you to activate or deactivate
the open windows function. The function is
activated by default.
This allows you to activate or deactivate the
ITCS function. The function is deactivated
by default.
This allows you to activate or deactivate
the "Pilot wire" function. The function is
deactivated by default. This function is only
available in France.
SCREEN
Publicité
Table des Matières
