Short/Long Messages; Gps Report - Kenwood NEXEDGE NX-200 Mode D'emploi

■ Reviewing Messages in the Stack Memory
(NX-200/300/200G/300G/205G/305G Only)
1 Press the key programmed as Stack, or press and hold
the key programmed as Selcall, Status, or Selcall +
Status to enter Stack mode.
• The last received message is displayed.
2 Press
• Message types are identified as follows:
I: Caller ID, S: Status Message, M: Short Message
• Press and hold
display information as follows:
ID Name > Status/Short Message > CH/GID > Time Stamp
3 Press
• To delete the selected message, press
To confirm the deletion, press
• To delete all messages, press and hold
To confirm the deletion, press

SHORT/LONG MESSAGES

Received short messages are displayed the same as Status
messages and are stored in the same stack memory (NX-
200/300/200G/300G/205G/305G Only).
To send and receive long messages, you must connect the
transceiver to a PC. Ask your dealer for details.

GPS REPORT

GPS data can be manually transmitted by pressing the key
programmed as Send the GPS data, or by accessing the
Menu {page 15}. If set up by your dealer, GPS data may be
automatically transmitted at a preset time interval.
• When using the NX-200G/300G/205G/305G, you must first
connect the VHF/ GPS antenna or UHF/ GPS antenna.
• When using the NX-200/300/200S/300S, you must first connect an
external GPS unit.
22
/ to select the desired message.
for 1 second or press
to return to normal operation.
to cycle the
or #.
or .
or # for 1 second.
or .