Transmitting - Kenwood NEXEDGE NX-200 Mode D'emploi

Select the desired channel/group ID using the Selector knob
(default). Each channel/group ID is programmed with settings
for transmitting and receiving.
• You can toggle the display between the zone and channel/group
ID names and number by pressing the key programmed as Display
Format, or by accessing the Menu (NX-200/300/200G/300G/205G/
305G Only) {page 15}.
Note: If the default settings for
205G/305G Only) and the Selector knob have been changed, use
the appropriate keys to select the zone and channel/group ID.

TRANSMITTING

1 Select the desired zone and channel/group ID.
2 Press the key programmed as Monitor or Squelch Off to
check whether or not the channel is free.
• If the channel is busy, wait until it becomes free.
3 Press the PTT switch and speak into the microphone.
Release the PTT switch to receive.
• For best sound quality, hold the transceiver approximately
1.5 inches (3 ~ 4 cm) from your mouth.
■ Making Group Calls (Digital)
(NX-200/300/200G/300G/205G/305G Only)
If a key has been programmed with Group or Group +
Status, you can select a group ID from the list to make a
call to those parties on a Conventional channel.
To select a group ID:
1 Press the key programmed as Group or Group + Status.
2 Press
3 Press and hold the PTT switch to make the call.
• Speak into the transceiver as you would during a normal
transmission.
/ to select a group ID/name from the list.
/
(NX-200/300/200G/300G/
13