Urmet DS1092-233 Guide Rapide page 17

Insert the cable that comes form the Power Box inside the bracket untile it gets out from the opposite side
Fix the the barcket of the Easy Dome to the Power Box (wth 4 screws and 8 washers available with the Power
Box)
Take the cable supplied withe the Dome off
Connect the cable coming from the bracket to the Dome connector
Fix the glass to to the housing screwing the 3 screws
Open the metal cover inside the plastic housing to find the configuration switch.
Follow the configuration settings for Easy Dome correct functioning (see paragraph – Dome settings).
Close the metal cover
Connect camera video output cable to the display device.
Connect Red/Black power cable to the included power supply.
Connect RS485 Yellow/Orange cable to the control keyboard.
Connect Yellow/Green cable to ground outlet.
5.1.3 CABLES SPECIFICATIONS
The system requires 3 types of cable:
4. Video cable for standard video composite signal transmission to display device. Use 75 Ohm coaxial cables.
5. Power supply cable for Easy Dome camera (12Vcc power supply).
6. RS485 command cable for command transmission from keyboard to Easy Dome camera. Use a double conductor
not shielded twisted cable. Suggested diameter 0,64 mm (22AWG).
DS1092-233 17