Bosch DHZ5485 Notice De Montage page 16

Installation
Apply the chimneys and fasten them on
with two screws to the chimney support
bracket (11) and make the lower part of
the chimney slide into the suited part on
top of the chimney.
11
Ø 2,9 x 6,5
• Reinstall the grease filters and the panel.
Warning! If the hood has to be used in
extractor version, remove, if supplied, the
carbon filter and the fastening wand
(placed on the back of the grease filters –
see relative paragraph).
If the hood has to be used in filtering
version, make sure that the carbon filter is
already mounted on the back of the
grease filter, or in case it's missing, buy it
and install it.
16
11
Note - only for installation without
flues: if you want to use the hood in the
filtering version, install the small grills/
deflector on the flanges.
Note: install the small deflector grills so
that the air is conveyed to the side
opposite the wall.