Bosch DHZ5485 Notice De Montage page 15

Installation
• Install the flange (9) with 2 screws.
Ø 3,5 x 9,5
• For exhaust-air mode only: Carry out the
connection of one tube (10A – tube and
ties for fastening not included, they need
to be bought) for the fume discharge to
the connection ring placed on top of the
extractor motor unit.
The other end of the tube should be
connected to a fume expulsion device
towards the outside, in case the hood is
used in extractor version.
• Only for chimney installation: In case
you want to use the hood in filtering
version, fasten the deflector F to the
support bracket, and connect the other
side of the tube to the connection ring
placed on the deflector (10F).
9
10A
10F
G
F
15