Ardisam Benchmark 38249 Manuel De L'utilisateur page 19

INSPECT CHIPPING KNIVES
Service Interval: Every 25 hours, or as necessary
The chipping knives of this unit can be rotated or sharpened to
provide a new cutting surface as required. When inspecting the
knives be careful to avoid touching the sharpened edges. To
inspect the chipping knives:
1. Disconnect the spark plug wire and secure it away from the
spark plug. SEE FIGURE 14.
2. Remove the nuts securing the chipper cone to the front of
the chipper. Remove the chipper cone to access the knives.
SEE FIGURE 13.
3. Using the recoil starter, slowly pull the starter rope to rotate
the rotor into position so the blades can be seen.
To sharpen or replace the chipper knives, see the Troubleshoot-
ing and Repair section.
CHECK / CHANGE ENGINE AIR CLEANER
Service Interval: Every 25 hours
The engine air cleaner assembly should be opened, inspected,
and the filter element replaced every 25 hours, or as required if
debris has built up in the assembly.
To replace the air filter, see engine manual.
REPLACE SPARK PLUG
Please contact your authorized repair center to perform
this service.
OIL MAINTENANCE
Refer to engine manual for oil maintenance.
212cc CHIPPER SHREDDER / BROYEUSE/DÉCHIQUETEUSE 212 cm
FOR THE SAFETY OF THE USER, AND TO MAXIMIZE THE
LIFE OF THE ENGINE, IT IS CRUCIAL TO TAKE TIME TO
CHECK THE CONDITION OF THE ENGINE. PROBLEMS MUST
BE CORRECTED BEFORE OPERATING.
AVOID INJURY!
HEALTH. DISPOSE OF OIL APPROPRIATELY. USE A SAFE
DISPOSAL/RECYCLING CENTER.
CHIPPER CONE
SPARK PLUG
Get parts online at www.ardisam.com or Call 800-345-6007 M-F 8-5 CST
Owner's Manual / Manuel de l'utilisateur
CAUTION
ENGINE OIL IS HAZARDOUS TO YOUR
3
38249 (5131-002)
FIGURE 13
FIGURE 14
19