Ardisam Benchmark 38249 Manuel De L'utilisateur page 13

CHIPPER CONE
H
Position the chipper cone over the three M8 x1.25 threaded
studs protruding from the engine plate, and attach using
three M8 nyloc nuts (H). Rotate cone and cone base away
from engine so cone does not contact engine. Tighten the
three M8 nyloc nuts (H) securely.
FIGURE 3
HOPPER
STUD PLATES
I
Install hopper by sliding slotted holes on the front side of
hopper onto the four studs on the front stud plate with the
previously loosened four M6 nuts (I). Reinstall rear stud plate
and back four M6 nuts (I) that were previously removed in
Figure 4. Tighten all eight M6 nuts (I).
FIGURE 5
212cc CHIPPER SHREDDER / BROYEUSE/DÉCHIQUETEUSE 212 cm
Remove back four M6 nuts (I) and set nuts and rear stud
plate aside. Loosen front four M6 nuts (I). Note: These will
not need to removed. Install the damper between the stud
plates as shown.
I
SLOTTED HOLES
Get parts online at www.ardisam.com or Call 800-345-6007 M-F 8-5 CST
Owner's Manual / Manuel de l'utilisateur
DAMPER
FIGURE 4
38249 (5131-002)
STUD PLATE
I
13
3