Hold the hopper handle up so that the outer holes in the handle
align with the holes in the hopper and secure with four M8 x 20
MM bolts (B), four M8 washers (E) and four M8 nuts (G). Insert
the screws from the outside of the hopper.
FIGURE 6
TABS
Slide the tabs on the debris bag onto the support rod. Secure
the bag connector onto the chipper by rotating
the connector until locked in.
FIGURE 8
14
Get parts online at www.ardisam.com or Call 800-345-6007 M-F 8-5 CST
212cc CHIPPER SHREDDER / BROYEUSE/DÉCHIQUETEUSE 212 cm
HOPPER HANDLE
G
E
B
Owner's Manual / Manuel de l'utilisateur
Slide the support rod into the bracket. Rotate the rod so that
it sits below the front tab of the bracket.
FIGURE 7
38249 (5131-002)
BRACKET
SUPPORT ROD
TAB
3