Features And Controls - Ardisam Benchmark 38249 Manuel De L'utilisateur

FEATURES AND CONTROLS

CONTROL FUNCTIONS
The information below briefly describes the function of individual controls. Operating requires the combined use of several
controls applied in specific sequences. To learn what combination and sequence of controls to use for various tasks see the
OPERATION section.
*For engine features and controls see engine manual.
CHIPPER CONE
KICKSTAND
CHIPPER CONE/SHREDDER HOPPER
Chipper Cone: The chipper cone is located on the front of the unit next to the engine. Insert branches and tree limbs up to
approximately 3" (7.6 cm) in diameter into the chipper cone. NEVER insert hands past the mouth of the cone.
Shredder Hopper: The shredder hopper is on top of the unit. Leaves and other light waste can be loaded into the shredder hopper.
Nothing over 1/2 inch in diameter should go into shredder. NEVER insert hands into the hopper .
Debris Bag: Use the debris bag to collect the material discharged from the unit. Do not operate the unit without the debris bag
in place.
10 Get parts online at www.ardisam.com or Call 800-345-6007 M-F 8-5 CST
212cc CHIPPER SHREDDER / BROYEUSE/DÉCHIQUETEUSE 212 cm
Owner's Manual / Manuel de l'utilisateur
38249 (5131-002)
SHREDDER HOPPER
FUEL CAP
DEBRIS BAG CONNECTOR
3