Whirlpool HybridCare Guide D'utilisation Et D'entretien page 19

2. Connect neutral bond wire and neutral
wire
Connect neutral bond wire (E) and neutral wire (white or center
wire) (C) of power supply cord or cable under center terminal
block screw (B). Tighten screw.
3. Connect remaining wires
Place remaining wires under outer terminal block screws. Tighten
screws.
4. Connect external ground wire
Connect a separate copper ground wire (G) from the green
external ground conductor screw (A) to an adequate ground.
Insert tab of terminal block cover into slot of dryer rear panel.
Secure cover with hold-down screw. Now, go to "Venting
Requirements."
19