Warning Labels; Important Safety Instructions For All Battery Packs - DeWalt DCT414 Guide D'utilisation

• Do not place the IR thermometer in a position which may
cause anyone to intentionally or unintentionally stare into
the laser beam. Serious eye injury could result.
• Do not disassemble the IR thermometer. There are no user
serviceable parts inside.
• Do not modify the IR thermometer in any way. Modifying the
tool may result in hazardous laser radiation exposure.
• Do not operate the IR thermometer around children or allow
children to operate the IR thermometer. Serious eye injury may
result.
• Do not remove or deface warning labels. Removing labels
increases the risk of exposure to radiation.
• Do not use IR thermometer for testing temperatures of
cooked or uncooked food.
• Do not use for taking human or animal body temperatures.
WARNING: Burn hazard. The reading may not be accurate if the
thermometer is in the presence of strong electromagnetic fields (such
as arc welders, induction heaters, ratio transmitters, etc.). Do not use
the IR thermometer under these conditions.
CAUTION: Use of controls or adjustments or performance
of procedures other than those specified herein may result in
hazardous radiation exposure.
• The label on your tool may include the following symbols.
V .............volts
mW .........milliwatts
..Laser warning symbol
nm ...........wavelength in nanometers
2 .............Class 2 Laser
3a ............Class 3a Laser

WARNING LABELS

For your convenience and safety, the following label is on your IR
thermometer (Fig. 2).
WARNING: LASER RADIATION DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT MAXIMUM OUTPUT POWER <1mW.
WARNING: ALWAYS use safety glasses. Everyday eyeglasses are
NOT safety glasses. Also use face or dust mask if cutting operation is
dusty. ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3)
WARNING: This product contains chemicals known to the State
of California to cause cancer, and birth defects or other reproductive
harm.
CAUTION: When not in use, place tool on its side on a stable
surface where it will not cause a tripping or falling hazard.
Some tools with large battery packs will stand upright on the battery
pack but may be easily knocked over.
Important Safety Instructions for All
Battery Packs
When ordering replacement battery packs, be sure to include catalog
number and voltage. Consult the chart at the end of this manual for
compatibility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below. Then
follow charging procedures outlined.
READ ALL INSTRUCTIONS
• Do not charge or use battery in explosive atmospheres,
such as in the presence of flammable liquids, gases or dust.
Inserting or removing the battery from the charger may ignite the
dust or fumes.
3