Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
COMPONENTS (Fig. 1–3)
WARNING: Never modify the power tool or any part of it. Damage
or personal injury could result.
A. Measurement trigger
B. Battery release button
C. D
WALT 12V Max* Lithium Ion Battery
E
D. Main handle
E. IR sensor
F. Laser/pointer beam
G. LCD screen
H.
Alarm mode button: is used to select the type of alarm and
to set the high (HAL) and low (LAL) temperature limits for
the alarm.
Alarm 1 – temperature has reached the set limit, indicated by
the red/blue LED (M)
Alarm 2 – temperature has reached the set limit, indicated by a
beeper sound
Alarm 3 – temperature has reached the set limit, indicated by
both the LED and the beeper
I.
Min/Max/Avg Mode Button: Displays either the lowest,
highest or average temperature.
J.
Adjustment Button: Used with each mode button to set
desired value.
K.
EMS Mode Button: Set emissivity value.
L.
C/F Mode Button: Used to set temperature units of
measure (Celsius or Fahrenheit).
M. LED Indicator - Active in Alarm 1 and Alarm 3 modes.
Blue: serves as alarm to show that temperature has reached the
set minimum.
Red: servers as alarm to show that temperature has reached the
set maximum.
N. Battery charger
SCREEN ICONS: (FIG. 3)
Hold – Will display after you
release the trigger to let you know
the last temperature read.
Scan – Will display while you
hold the trigger down looking for
differing temperatures.
Alarm setting – this icon will let
you know what alarm you have
chosen to display; color indicator,
beep or both.
F or C – Indicates units of
measure for temperature
Battery – Will indicate how much
charge is remaining on the battery.
NOTE: The low battery indicator
is located directly above the
temperature reading on the screen. The bars on low battery
indicator will indicate the strength of the battery. The IR
Thermometer may continue to operate for a short time while the
batteries continue to drain, but the beams will quickly dim. After
fresh batteries are installed, and the IR Thermometer is turned on
again, the IR Thermometer will return to its full brightness.
9
FIG. 3
M
G
L
H
I
J
K
Publicité
Table des Matières
