EGO PRO X PTX5100 Mode D'emploi page 11

TROUBLESHOOTING
CAUSE
PROBLEM
◾
No electrical contact between the trimmer
and battery.
◾
The battery pack is depleted.
◾
The battery pack or tool is over-
Hedge trimmer doesn't
temperature protection
work.
◾
The blade is jammed.
◾
Dry or corroded blades.
◾
Blades or blade support is bent.
Excessive vibration or
◾
Bent or damaged teeth.
noise.
◾
Loose blade bolts.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.eu for full terms and conditions of the EGO Warranty policy.
56-VOLT LITHIUM-ION HEDGE TRIMMER ATTACHMENT — PTX5100
SOLUTION
◾
Remove battery, check contacts and
reattach the battery pack.
◾
Charge the battery pack.
◾
Allow the battery pack or power pole
to cool until the temperature drops
below 67°C.
◾
Remove the battery pack from the
tool. Remove the obstruction carefully
and then reinsert the battery and
restart the tool.
◾
Lubricate the blades.
◾
Replace with a new blade or support
following the section" REPLACING THE
BLADE" in this manual or contact EGO
service center for replacement.
◾
Replace with a new blade following
the section" REPLACING THE BLADE"in
this manual or contact EGO service
center for replacement.
◾
Tighten the blade bolts. Using a hex
wrench (not included), turn the bolt
clockwise to tighten.
EN
11