Product Description - Ayce NT9008-20E Mode D'emploi

PRODUCT DESCRIPTION

1 Handle 5
Control & display panel
2 6
3 Knob 7
Air inlet
4 8
OPERATION
Note!
Since the appliance and its heating coils are slightly greased when delivered, there
might be a slight development of smoke and odour the first time it is used. This is harmless
and stops after a short a while. Be sure to provide for su cient ventilation during such time.
Warning!
Ensure that there is su cient distance from the wall, fixtures or other appliances.
The distance must be at least 1 m to exclude the risk of fire.
Take the appliance and all the accessory parts out of the packaging.
1.
2. Check that the appliance shows no signs of damage.
Select a location that is firm, level and incombustible.
3.
4. Insert the mains plug into a suitable wall socket with 220 – 240 V~ 50/60 Hz and a current
carrying capacity of at least 10A.
5. Please be sure power switch is on " OFF" position.
Base
Switch
Wind net
Back cover
1. Control panel schematic diagram；
OSC
TEM POWER
2. Connect the power cord, open the back switch on the back , the machine electricity will take
into standby mode, then the light in the middle of the icon "88" is bright
the light is not bright; (The switch on the back "I" is on , "O" is o ).
3. ON/OFF" ":In standby mode, press the button
to the preset functions start work (PTC low-grade open, low light is lit, the digital display
shows the ambient temperature ), press the button
and then go into standby mode; (After the machine turns o when the machine in a warm
wind state, the blower will delay to work for 10 seconds, the cold air icon
the delaying process), Then turn o the switch to "O", and then pull the plug out after using.
4. Temperature" " is used to temperature setting, press temperature
the set state, the temperature icon
temperature, continue to press temperature
interval to 5 ℃, increase in sequence; After setting is completed, it will automatically exit
within 5 seconds if no operation on the appliance. The temperature icon
the digital display shows ambient temperature. At this time the machine in
accordance with the set temperature starts to work. When the ambient temperature is higher
than the set temperature, the machine will stop working, and if the ambient temperature is
lower than the set temperature, the machine will return to work.
5. Timing" " is used to set a regular shutdown time; press
state, timing shutdown icon light, the icon
setting time; Continue to press time
42 | 43
TIMER
GEAR REV
,but the rest of
once the machine turns on, according
once again, all functions will close
will flash in
once to enter into
flashing, the digital display shows the current set
Settings (15 to 35 ℃ can be set), set the
stops flashing,
once to enter into the set
flashing , the digital display shows the
once and more time setting, press 1 h interval
GB