Makita LS1018 Manuel D'instruction page 14

Securing workpiece
WARNING:
• It is extremely important to always secure
the workpiece correctly with the proper type
of vise or crown molding stoppers. Failure to
do so may result in serious personal injury and
cause damage to the tool and/or the workpiece.
• After a cutting operation do not raise the
blade until it has come to a complete stop.
The raising of a coasting blade may result in
serious personal injury and damage to the
workpiece.
• When cutting a workpiece that is longer
than the support base of the saw, the mate-
rial should be supported the entire length
beyond the support base and at the same
height to keep the material level. Proper
workpiece support will help avoid blade pinch
and possible kickback which may result in seri-
ous personal injury. Do not rely solely on the
vertical vise and/or horizontal vise to secure the
workpiece. Thin material tends to sag. Support
workpiece over its entire length to avoid blade
pinch and possible KICKBACK.
1
► 1 . Support 2. Turn base
Guide fence (SLIDING FENCES)
adjustment
► 1 . Sliding fence 2. Clamping screw
2
1
2
14 ENGLISH
CAUTION:
• Before operating the tool, make sure that the
sliding fence is secured firmly.
• Before bevel-cutting, make sure that no part
of the tool, especially the blade, contacts
the sliding fence when fully lowering and
raising the handle in any position and while
moving the carriage through its full range
of travel. If the blade makes contact with the
sliding fence, this may result in kickback or
unexpected movement of the material and
serious personal injury.
► 1 . Sliding fence
CAUTION:
• When performing bevel cuts, slide the sliding
fence to the left and secure it as shown in the
figure. Otherwise, it will contact the blade or a
part of the tool, causing possible serious injury
to the operator.
This tool is equipped with the sliding fence which should
ordinarily be positioned as shown in the figure.
However, when performing left bevel cuts, set it to the
left position as shown in the figure if the tool head con-
tacts it.
When bevel-cutting operations are complete, don't for-
get to return the sliding fence to the original position and
secure it by firmly tightening the clamping screw.
Sub-fence R
WARNING:
• Before operating the tool, make sure that the
sub-fence R is secured firmly.
• Before performing right bevel cuts, remove the
sub-fence R. It will contact the blade or a part of
the tool, causing possible serious injury to the
operator.
1