Instructions For Daily And Periodic Maintenance; Service, Spare Parts And Guarantee - Makita DCS34 Manuel D'emploi Et De Sécurité

Instructions for daily and periodic maintenance

To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be performed
regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform the prescribed
maintenance work can lead to accidents!
Perform the following servicing work daily after use. Make a habit of it, it does not require much time and your saw will always function
properly.
Possibly hidden faults can be detected in this manner before causing expensive and annoying interruptions of your work. In case
you should detect a fault in the safety equipment when performing daily servicing, the saw must not be used before elimination of
the fault.
The user of the chain saw must not perform maintenance work which is not described in the operator's manual. All such work must
be carried out by a MAKITA service center.
General
Before each start
Every day
Every week
Every 3 months
Annually
Storage

Service, spare parts and guarantee

Maintenance and repair
The maintenance and repair of modern engines as well as all safety devices require qualified technical training and a special work-
shop equipped with special tools and testing devices.
We therefore recommend that you consult a MAKITA service center for all work not described in this operator's manual. The MAKITA
service centers have all the necessary equipment and skilled and experienced personnel, who can work out cost-effective solutions
and advise you in all matters.
Please contact your nearest service center. Should you however not have an adress for a MAKITA service center then please contact
the MAKITA general trading company (see last page) who will gladly provide you with the adress of your nearest MAKITA service
center.
32
Chain saw
Saw chain
Chain brake
Guide bar
Starter cable
Spark arrester screen
Saw chain
Guide bar
Chain lubrication
Chain brake
Combination switch,
Throttle stopper,
Throttle lever
Fuel/oil tank plug
Air filter
Guide bar
Guide bar support
Idle speed
Fan housing
Spark plug
Muffler
Chain catch
Screws and nuts
Fuel filter
Fuel, oil tanks
Chain saw
Chain saw
Chain, guide bar
Fuel, oil tanks
Carburetor
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately
Sharpen regulary, replace in good time
Have inspected regularly at an authorized service center
Turn over to ensure even wear of bearing surfaces
Replace in good time
Check for damage. In case of damage,
have repaired by a qualified service center immediately
Inspect for damage, clean if clogged
Inspect for damage and sharpness
Check chain tension
Check for damage
Functional check
Functional check
Functional check
Check for tightness and lekages
Clean (more often if necessary)
Check for damage, clean oil intake bore
Clean, in particular the oil guide groove
Check (chain must not run)
Clean to ensure proper air cooling
Check and replace if necessary
Check tightness of mounting
Check
Check their condition and that they are firmly secured.
Replace
Clean
Check at an authorized service center
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service center immediately
Demount, clean and oil slightly
Clean the guide groove of the guide bar
Empty and clean
Run empty
Page
27-28
2, 29
3
27-28
2
24
26
25
30
29
29
26-27
7
3
31
7
30
29