Roborock Q5 Pro+ Manuel D'utilisation page 8

the dock will not be dragged away or disconnect from
the power supply.
• Keep the dock away from direct sunlight or anything
that may block the dock location beacon; otherwise,
the robot may fail to return to the dock.
• The Auto-Empty Dock recharges and empties. Store
the standard robot dock before use. Failure to do so
may cause issues returning to dock.
• Maintain the dock according to the maintenance
instructions. Do not clean the dock with a wet cloth.
• Avoid frequent manual emptying.
• Images are for illustration purposes only and may not
exactly represent the product.
Powering on & Charging
B3
Press and hold the button to power on
the robot. Wait until the power light is
steady, and then place the robot on the
dock to charge. The robot is equipped with
high-performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
The robot may not turn on when the battery is
Note:
low. In this case, place the robot directly onto the dock
to charge.
Using the mopping module
B4
B4-1—Adjust the water flow
Slide the switch down to increase the water
flow and up to decrease the water flow.
B4-2—Fill the water tank
Remove the water tank stopper, fill it with
water, and close it.
B4-3—Install the mop cloth
Dampen the mop cloth and wring it until it
stops dripping. Insert it into the bottom
along the attachment slot and stick it firmly
in place.
B4-4—Install the mopping module
Slide the mopping module along the back
of the robot as indicated by the arrow. A
click indicates that it is locked in place.
Notes:
• To prevent excessive dirt buildup during first-time use,
floors should be vacuumed at least three times before
mopping.
• If carpets are present, draw No-Go Zones or Invisible
Wall to prevent the robot going on them, or roll them
up.
• To avoid water tank corrosion, do not use cleaning
fluid or disinfectant.
• The mop cloth should be cleaned after 60 minutes
of mopping to ensure water flow and cleaning
performance.
Remove the mopping module
B5
When the robot returns to the dock after
cleaning, press the latches on both sides,
and slide the mopping module backwards
to remove it.
Notes:
• Wash the mop cloth after each use, and regularly
empty the water tank of unused water to prevent odor.
• Remove the mopping module when not mopping.
Connecting to the App
This robot supports both Roborock and Mi
Home apps. Choose the one that best
meets your needs.
09
❶ Download App
Option 1: Search for "Roborock" in the App
Store or Google Play or scan the QR code to
download and install the app.
Option 2: Search for "Mi Home" in the App
Store or Google Play or scan the QR code to
download and install the app.
❷ Reset WiFi
Press and hold the and buttons until
you hear the "Resetting WiFi" voice alert.
The reset is complete when the WiFi
indicator flashes slowly. The robot will then
wait for a connection.
Note: If you cannot connect to the robot due to your
router configuration, a forgotten password, or any
other reason, reset the WiFi and add your robot as a
new device.