Electrolux ELFE4222AW Instructions D'installation page 9

Masquer les pouces Voir aussi pour ELFE4222AW:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Electrical Connection
(Non-Canada) - 3-wire
Cord
3-wire receptacle
(NEMA type 10-30R)
30 AMP
NEMA 10-30
Neutral (center wire)
1
NOTE
Two cords shown above with different
terminal types.
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before
servicing could result in personal injury or
even death.
1. Turn off power supply to outlet.
2. Remove the three screws securing the
terminal block access cover in the upper
corner on the back of the dryer.
NOTE
Terminal screws were shipped from the factory
temporarily attached inside the access cover.
1
Terminal Block Access Cover
1
Installation Instructions
3. Using an UNPLUGGED, UL-approved,
30 amp. power cord, NEMA 10-30 type
SRDT, attach the neutral (center wire)
conductor to the SILVER colored center
terminal on the terminal block. Tighten the
screw securely.
WARNING
ELECTRICAL SHOCK HAZARD
DO NOT move internal ground in a 3-wire
system.
1
3
4. Attach the remaining two power cord
outer conductors to the outer, BRASS
colored terminals on the terminal block.
Tighten both screws securely.
4
4
WARNING
ELECTRICAL SHOCK HAZARD
Do not make a sharp bend or crimp wiring/
conductor at connections.
3
Neutral Silver Terminal
4
Outer Brass Terminals
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Elfe422caw

Table des Matières