Cleaning The Housing; Cleaning Your Hair And Beard Clippers - SilverCrest SHBS 1000 A1 Instructions D'utilisation Et Consignes De Sécurité

Cleaning the housing

Q
C lean the housing using a slightly moist cloth.

Cleaning your hair and beard clippers

Q
S witch off the hair and beard clippers by pressing the ON / OFF
switch .
3
D isconnect the lead from the device and pull the plug-in mains
adapter out of the mains socket.
T ake any fitted cutting length comb attachment
W ash the cutting length comb attachments
holding them under flowing water.
T hen fully dry the attachments.
U sing your thumb from the front of the device, press against the
teeth of the cutter head to release the blade set
(see Fig. B).
U se the supplied cleaning brush to remove any remaining hair
residue from the blade set
A fter cleaning, place the locating lug of the blade set
into the locating hole of the cutter head mount (see Fig. C).
R e-engage the blade set
the rear of the device (see Fig. D).
Tip: To reduce friction apply one or two drops of cutter oil (accessory)
from time to time between the blades and spread it out evenly. You
may also use any acid-free oil (such as sewing machine oil). Wipe
away any excess oil with a cloth.
Cleaning and care
.
1
by applying a little light pressure from
1
off the device.
6
when necessary by
6
from its mount
1
back
1
GB 59