Baby Unit; Features; Avoiding Interference - Philips SCD465 Mode D'emploi

Avoiding interference

Always make sure that the channel selection switches (A-7,
B-10) inside the battery compartments on both units are set to
the same position!
With the channel selection switches (A-7, B-10) you can select
sixteen different channel positions. If you experience
interference from other baby monitors, radio devices, etc. select
a different channel.
1 Open the battery compartment covers (A-8, B-12) of both
units.
• Parent unit: use a screwdriver and slide down the cover.
• Baby unit: use a coin.
2 Lift up the rechargeable battery pack (B-13) of the parent unit.
If you are operating the baby unit on battery power, remove
the batteries from the unit.
3 Use a small, flat screwdriver to rotate the inner circle of the
channel selection switches (A-7, B-10) to the desired position.
Make sure both units are set to the same channel.
4 Put batteries and battery pack back in place.
5 Close the battery compartment covers (A-8, B-12).
(channel selection)

Features

EN
9