SilverCrest SSVF 45 A1 Mode D'emploi page 11

7. Position the rear protective grid 5 exact-
ly in the centre and screw it tight with
the screw ring 4.
8. Place the rotor blade 3 on the axle 6,
making sure that the groove on the
back of the rotor blade is positioned ex-
actly on the small pin on the axle.
9. Put on the cap nut 2 and screw it tight
in the TIGHTEN direction (anticlock-
wise). Hold the rotor blade 3 with the
other hand, if necessary.
10. Test whether the rotor blade 3 can be
turned freely by hand without touching
other parts. If this is not the case, disas-
semble and reassemble the rear protec-
tive grid 5 and the rotor blade 3.
11. Place the front protective grid 1 onto
the rear protective grid 5. Pay attention
to the following:
- The small hook on the edge of the
front protective grid 1 is hung over
the top of the edge of the rear protec-
tive grid 5.
- The two holes for the connecting
screw 18 at the lower edge of the
protective grids 1 and 5 must be ex-
actly on top of each other.
9
GB