WOLFF VARIO BRAVO-STRIPPER 013343 Mode D'emploi page 12

3
09/2002 VARIO-STRIPPER , Artikel-Nr.
1
o
I
4
o
I
2
blade`s width Messerbreite 1
6 5 4 3 2
013343Fu
5.0 Use
Assembling the machine
Mount the handle with the thumb screw to the housing. To
assemble the clutch, just press the socket joint onto the clutch
lever at the machine housing.
For your safety the BRAVO-STRIPPER comes with the blade
not mounted. Make sure that the power supply is disconnected
before mounting the blade. The sharp bevel of the blade must
always face up and the blade must sit close to its support.
See also Chapter 4.0 Maintenance, "Changing the blade".
Operating panel
Operate the BRAVO-STRIPPER at the operating panel on top
of the handle.
switch (1) actuates the blade action
r
r switch (2) actuates the motor drive
r switch (3) controls the speed in the range of 4 to 10 m/min
The indicator lamp (4) indicates power-on. In operation, engage
the motor drive with the hand clutch, and not with switch (2).
Starting
The BRAVO-STRIPPER is equipped with a power-on indicator
lamp and an operating switch located at the top of the handle.
The switch has a restart protection for low-voltage failures.
If the lamp does not indicate power-on, use another power
socket or check power supply.
If a mains power failure occurs during operation, switch-on the
machine again.
Use
The BRAVO-STRIPPER removes bonded, flexible floor coverings
in strips. It uses an oscillating system, i.e. the blade performs a
circular movement. This movement results in a lateral cutting.
This could make the stripper swing sideways if you want to
remove stiff flooring or aggressive adhesive. In this case using
the device may be limited due to its system. Before starting
work, the flooring needs to be cut into strips of the blade's width.
To begin, cut one strip crosswise. Then lift the flooring slightly in
order to get the blade underneath it.
We recommend to cut the first strip at right angles to the main
working direction. By so doing access to the next strips is made
easier. Cut the strips smaller if the floor covering is bonded very
securely, e.g. with an epoxy adhesive.
The blades are sharpened by the floor pavement. Therefore the
blade has to be changed only if it is twisted or becomes worn.
12