Elica INTERSTELLAR Prescriptions De Montage Et Mode D'emploi page 31

shortly.
LED L1 lights up steady with a red light (warning on) and then
starts to flash (warning off).
Repeat the operation if you want to reactivate the warning. LED
L1 switches from flashing red (warning off) to a steady light
(warning on).
Filter saturation warning reset
With the hood off, press keys T1 and T2 simultaneously for at least 5
seconds. LED L1 will stop signalling saturation.
Repeat the operation in case of simultaneous warnings of both filters.
Remote control affiliation
The affiliation of the remote control is displayed with both LEDs ON..
Maintenance
Cleaning
Clean using ONLY a cloth dampened with neutral liquid detergent.
DO NOT CLEAN WITH TOOLS OR INSTRUMENTS. Do not use
abrasive products. DO NOT USE ALCOHOL!
Grease filter
Fig. 25-26-27
Traps cooking grease particles.
This must be cleaned at least once a month (or when the filter
saturation indication system - envisaged on the model in possession -
indicates this necessity), using non-aggressive detergents, in a
dishwasher, which must be set to a low temperature and a short
cycle (Tmax: 70°C).
When washed in a dishwasher, metal parts may discolour slightly.
The filter must be dried in an oven for one hour at a max temperature
of 100°C; if the filter is still moist, repeat the operation.
Replace the filter at least every 2 years.
Attention! After having performed maintenance on the filter, FIRST
install the grease filter in the specific container and THEN the
charcoal filter. The latter can be recognised as it is sealed inside a
braiding.
Once the container has been repositioned, make sure only the
grease filter is visible.
Charcoal filter (filter version only)
Fig. 25-26-27
It absorbs unpleasant odors caused by cooking.
Attention! The active charcoal filter can be recognised as it is sealed
inside a braiding. Perform disassembly, maintenance and cleaning
operations of the filter, managing it with the utmost care to avoid
damaging or opening the braiding.
The charcoal filter can be washed once every two months (or when
the filter saturation indication system – if envisaged on the model in
possession – indicates this necessity) using hot water and a suitable
detergent, or in a dishwasher at 65°C (if the dishwasher is used,
select the full cycle function and leave dishes out).
Eliminate excess water without damaging the filter, then put it in the
oven for 10 minutes at 100° C to dry completely. Replace the
mattress every 3 years and when the cloth is damaged.
Attention! After having performed maintenance on the filter, FIRST
install the grease filter in the specific container and THEN the
charcoal filter. The latter can be recognised as it is sealed inside a
braiding.
Once the container has been repositioned, make sure only the
grease filter is visible.
Replacing lamps
Fig. 25
The hood is equipped with a lighting system based on LED
technology.
The LEDs guarantee an optimum lighting, a duration up to 10 times
longer than the traditional lamps and allow to save 90% electrical
energy.
The lighting system cannot be replaced by the user, contact
Customer Service in case of malfunction.
30