Applications; Filling The Tank - Ryobi PSP01 Manuel D'utilisation

WARNING:
Use safety equipment. Protect your eyes, skin, and lungs
while mixing, filling, spraying, and cleaning. Failure to do
so may result in serious personal injury and damage to
property.
NOTICE :
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.

APPLICATIONS

You may use this product for the purposes listed below:
 For use with most consumer grade disinfectants and
sanitizing solutions
WARNING:
If this product is used for herbicide/insecticide applica-
tions do not re-purpose it for use with disinfectants. Ob-
tain a second nozzle set and tool for dedicated use with
disinfectants only. Tools used for herbicide/insecticide
applications are regulated under EPA Federal Insecticide,
Fungicide, and Rodenticide Act regulations and are con-
sidered contaminated.

FILLING THE TANK

See Figures 1 - 3, page 11.
WARNING:
Before filling the tank, always remove the battery pack.
Wipe up any spills before inserting the battery pack. Fol-
lowing this rule will reduce the risk of electric shock and
corrosive liquids entering the battery pack, which can
cause battery pack failure including short circuit resulting
in smoke, fire, and/or serious personal injury.
OPERATION
Always follow the chemical manufacturer's instructions
printed on their product labeling for use, cleaning, and
storage. Do not combine chemicals. Clean thoroughly
after each use, following the instructions in the
Maintenance section of this manual. Chemicals should
be stored out of the reach of children. Failure to do so
may result in serious personal injury.
Do not allow conductive or corrosive fluids to get inside
the battery pack. If conductive or corrosive fluids are
spilled on the battery, refer to the instructions in your
battery operators manual.
NOTICE :
Remove tank and fill away from sprayer. Clean the exterior
of the tank and clean up any spillage before replacing
tank.
When adding spray solutions, you may add water and the
desired chemical solution directly into the tank, or use a
solution that has been premixed in a separate container,
then poured into the sprayer, using a funnel if needed. For
either method, remember:
 Liquids used must be as thin as water. Thicker liquids will
not spray properly.
 Do not overfill the tank.
NOTE: If using a measuring container or funnel to fill the
tank, be sure to thoroughly clean and rinse these items after
use. If premixing the spraying solution, rinse the container
used for mixing.
To fill:
 Remove the battery pack.
 Unlock the latches securing the tank to the sprayer.
 Tilt the base of the tank away from the sprayer and then
remove it.
 Unscrew the cap and remove it from the tank.
7 – English
WARNING:
WARNING: