TopCold 310 Manuel D'utilisation page 7

your product. These kind of living creatures might
damage the electrical system and cause fire.
24. Frost shall be increased for products, of which
the doors are kept open or frequently open and
closed, and the appliance shall have difficulty in per-
forming the cooling operation. Thus, open the door
of your product when it is required only. Ensure that
the door of your product is closed when you do not
require.
25. Do not unplug your product for saving power if
you shall not use your product or keep it empty for
a short period. Otherwise, more power shall be used
for cooling your product again. Just bring the ther-
mostat position to a lower setting.
26. Follow the instructions specified in this manual
for replacement of lamps. The rating of the lamp to
be replaced is specified on the identification plate of
the appliance and on the plate under the lamp. (*)
27. Do not intervene the appliance directly in case of
a fault that occurs due to the electrical system of the
appliance or of the installation where the appliance is
connected. Unplug the appliance and disconnect the
power of the device by turning the main switch off
and contact nearest Simfer authorized service.
28. If the power supply cable is damaged, it must be
replaced by its manufacturer or authorized technical
service or any other personnel qualified at the same
level, in order to avoid any dangerous situation.
7