Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TABLE TOP CLAMPING
Wood Project Clamp not included
(1) The Bench Clamp rotates 360°. (2) Slide a Wood Project Clamp (optional
accessory) anywhere along the edge.
CLAMP VISE
2
1
(1) Install the Bench Clamp in lower keyhole slot.
(2) Install the Support Bracket in middle slots.
(3) Rest the workpiece on Bracket and (4) clamp.
MOUNTING A KREG JIG
Align the jig with the corresponding holes for either K4 or K5.
1
2
(1) Insert Bench Dogs into holes, (2) position workpiece, and (3) clamp.
3
4
Mount the Support Bracket in the middle slots.
®
2
K5 alignment hole
K4 alignment hole
(1) Hang Kreg screw containers from the edges of the table tops.
ATTENTION
(2) Store hardware in the recessed trays.
(3) Drill Holsters keep a drill/driver handy.
CLAMPING WITH BENCH DOGS
1
2
BRACKET POSITION: CLAMP VISE
ADDITIONAL FEATURES
Hang only Kreg 100-count and 250-count screw containers
3
2
3
1
Publicité
Table des Matières
