Oase BioMaster 250 Notice D'emploi page 17

Cleaning and maintenance work:
Area
Foam filter, pre-filter
Filter media, filter unit
Heater
Impeller unit, pump casing
Valve box, pre-filter
Suction chamber, pre-filter
NOTE
The cycle for cleaning the foam filter in the pre-filter is longer if a coarser foam filter is used.
Cleaning/replacing the filter foams of the pre-filter
Prerequisite: The pre-filter has been removed. (→ Removing the pre-filter
How to proceed:
S
1. Turn the casing until the locking hooks are pushed in, then pull off the casing.
2. Remove the pre-filter pipe and filter foams.
– BioMaster 250/BioMaster Thermo 250: 4 filter foams
– BioMaster 350/BioMaster Thermo 350: 5 filter foams
– BioMaster 600/BioMaster Thermo 600: 6 filter foams
3. Rinse the filter foams in warm water. If necessary, replace the filter foams (→ Wear Parts P.20).
4. Assemble the pre-filter in the reverse order.
– Ensure that the locking hooks lock in place in the casing.
Tasks to be carried out
(→ Cleaning/replacing the foam filter of the pre-filter P.17)
(→ Cleaning/replacing the filter media P.18)
HeatUp instruction manual
25/50/100/150/200/300
(→ Cleaning/replacing the impeller unit P.19)
(→ Cleaning the valve box of the pre-filter P.19)
(→ Cleaning the suction chamber of the pre-filter P.20)
)
P.8
- EN -
17