Preparing The Remote Control; Assembling Concealed Cistern - Invacare Aquatec Pure Manuel D'utilisation

Aquatec® Pure Bidet

Preparing the remote control

A
Remove battery cover A from remote control.
1.
Insert batteries B. Ensure correct polarity.
2.
3. Close battery cover of remote control.
4. Place remote control D into its holder C.

4.2 Assembling concealed cistern

Installing water flow over angle valve
1. Connect angle valve and bidet with the PVC Flexible hose
(accessory).
2. Turn the water tap on.
IMPORTANT!
– Check the connection for leaks and re-fit if necessary.
Installing water flow over flush-mounted housing
14
B
A
C
1. Remove the push plate from the flush-mounted housing.
2. Remove the rear cover plate to obtain a direct perspective on
the connection.
3. Turn the water tap off.
Remove connecting sleeve D and replace by T-piece E.
4.
Connect T-piece with PVC Flexible hose C.
5.
Connect PVC Flexible hose with tube A using nut B.
6.
Connect tube A with pure bidet.
7.
8. Turn the water tap on.
IMPORTANT!
– Check the connection for leaks and re-fit if
necessary.
9. Cut-out inner cover plate F, mounting plate G and push plate H
according to the figure above taking into account the indicated
dimensions [mm].
10. Re-attach the inner cover plate and the mounting plate inside the
flush-mounted housing.
11. Close flush-mounted housing with the push plate.
Following parts are needed for the assembly of the
flush-mounted water flow but are not included in the scope
of delivery:
• Tube A
• Nut B
Available at your specialised dealer.
1590625-A