Door Conversion - Domo LINEA 2000 DO917GDK Mode D'emploi

3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws (10) that hold the handle (11) (on the right side frame).
Change the handle to the left side frame.
5. Remove the two screws(8) that hold the lower hinge(2) and Make sure to
· Allow the appliance to stand for 2 hours before turning it on. This allows the cooling agent
Remove the lower hinge(2).
to settle.
6. Remove the left front leg (4) and transfer it to the right side.
· After installation, leave the freezer for 12 hours before turning it on. This way the
7. Remove the hole cover plate(7) to the right side.
refrigerant can settle.
8. Before placing this lower hinge(2), remove the bolt-pin (9) and reverse
the direction of the lower hinge(2). Then install the lower hinge (2) onto
the left side of the lower frame with two screws (8).

DOOR CONVERSION

9. Insert the bolt-pin(9) to the lower hinge (2).
10. Set the door to its place making sure the door seat at the lower hinge(2)
The refrigerator has a reversible door. If you need to hinge your door on the opposite side it is
.
11. While holding the door in the closed position secure the upper hinge (5) in the
recommended that you call your local authorised service agent to make this conversion or ask
top frame of left side with two screws (1). Please remember that do not tighten
a technician.
the two screws(1) until the top of the door is levelled with the counter top.
Before you reverse the door, you should ensure the appliance is unplugged and empty. 12. Install the upper hinge cover(6) on the upper hinge..
1
7
2
8
4
Door opening from left side
1. Remove the cover plate (6) of the hinges.
2. Remove the two screws (1) of the upper hinge (5). Remove the hinge.
3. Lift the door off and place it on a soft surface to prevent scratching.
4. Remove the screws (10) of the handle (11). Move the handle to the other side.
5. Remove the screws (8) and the hinge (2) to the other side of the door.
6. Remove the adjustable foot (4) and place it on the other side.
7. Move the cover plate of the drill holes (7) on the top of the refrigerator to the other side.
8. Before you replace the bottom hinge (2), remove the hinge pin (9) and reverse the
direction of the hinge. Replace the hinge (2) on the other side and fasten it with the two
screws (8).
9. Place the hinge pin (9) in the hinge (2).
10. Position the door on the lowest hinge (2).
11. Grip the door in a closed position and fasten the top hinge (5) with the two screws (1).
With the door closed, check whether the door is aligned horizontally as well as vertically
and that the seal closes on all sides before you tighten the upper hinge (5) completely.
12. Replace the cover plate (6). If necessary, adjust the adjustable feet.
www.domo-elektro.be
6
5
10
11
9
3
15
7
1
6
5
2
4
9
8
3
Door opening from right side
10
11
Page 15 from 20
DO917GDK
33