Thermador Professional PRO HARMONY PRG30 Manuel D'installation page 9

Gas and Electric Supply
Note:
If not already present, install gas shut-off valve in an easily
accessible location. Make sure all users know where and
how to shut off the gas supply to the range.
Note:
The installer should inform the consumer of the location of
the gas shut-off valve.
Note:
Any opening in the wall behind the appliance and any
opening in the floor under the appliance must be sealed.
The gas ranges may be connected to the power supply
with a range supply cord kit or by hard-wiring to the power
supply. It is the responsibility of the installer to provide the
proper wiring components (cord or conduit and wires) and
complete the gas connection as dictated by local codes
and ordinances, and/or the National Electric Code. The
units must be properly grounded. Refer to Step 6 for
details.
Gas & Electrical
Supply Zone
D
A B
30" (30" models)
36" (36" models)
Model A B
30" 5-3/4" 18-7/16"
36" 8-1/16" 19-13/16"
Figure 3a: Gas & Electrical Supply Locations for All Gas Ranges
2-1/2" maximum protrusion
from wall for gas or
electrical supply
2-1/2"
C
C D
5-13/16" 2-15/16"
8-1/8" 3-3/16"
The range must be connected only to the type of gas
for which it is certified. If the range is to be connected to
propane gas, ensure that the propane gas supply tank is
equipped with its own high pressure regulator in addition to
the pressure regulator supplied with the range. (See
Step 5.)
Note:
The range is designed for flush installation to the back wall.
For a successful installation, it may be necessary to
reposition the gas-supply line and electrical cord as the
range is pushed back to its final position.
SUGGESTION: This may be accomplished by carefully
pulling on a rope or twine looped around the gas or
electrical supply line as the range is pushed back into
its final installed position.
English 7