Thermador Professional PRO HARMONY PRG30 Manuel D'installation page 11

Pallet
Figure 4: Removal of the Four (4) Shipping Bolts
Note:
Leave adhesive-backed foam layer over brushed-metal
surfaces, to protect finish from scratches, until the range is
installed in final position.
• Due to the weight, a dolly with soft wheels should be
used to move this unit. The weight must be supported
uniformly across the bottom (See Figure 5).
• After transporting the professional range by dolly close
to its final location, the range can be tipped back and
supported on the rear legs while the dolly is carefully
removed. THE FLOOR UNDER THE LEGS SHOULD
BE PROTECTED BEFORE PUSHING THE UNIT
INTO POSITION. The anti-tip device must be installed
(STEP 4), gas and electrical connections should be
made (STEPS 5 and 6), and the backguard installed
(STEP 7) before the range is placed in its final position.
• For proper performance, the range must be level. (It
is very important for all products that have the griddle
feature.) The range is leveled by adjusting the legs with
a wrench.
• Replace the kick panel. It is important that the two
(2) screws retaining the kick panel are secure to
prevent accidental access to hot surfaces.
• Ensure that the burner caps are correctly seated on
the burner bases of the range's cooktop.
Remove all tape and packaging before using the appliance.
Destroy the packaging after unpacking the appliance.
Never allow children to play with packaging material.
Important:
DO NOT lift the range by the oven door's handle, as this
may damage the door hinges and cause the door to fit
incorrectly to the oven cavity.
Griddle Tilt Adjustment (Not All Models)
If the range is equipped with an electric griddle, check the
griddle frame adjustment by pouring two tablespoons of
water on the back of the griddle plate. The water should
slowly roll into the grease tray. If not, adjust the two screws
under the back of the frame. Start with one half turn
counterclockwise (CCW) of the screws. Further adjustment
should be made by one-quarter turn until water slowly flows
into the grease tray.
Range
Must be
Uniformly
Supported
by Braces
Provided
on Bottom
of Range
Figure 5: Dolly Positioning
English 9